CLID on networked PBX

[dannoWI]

PBX-A has a PRI to the CO. PBX-A and PBX-B are connected via PRI Tie lines. Clid from PBX-A to CO is 3553800 as programmed in clid table. This works fine. Calls local to PBX-A are sent from PBX-B but the clid sent out is the PBX-B number. I need the clid to be the same when going out the CO PRI no matter which PBX it originated from. I can't change the clid table on PBX-B as it must send out it's own clid to it's own PRI. Hope I explained this correctly.

Answer The Phone!

 

[johnpoole]

if you want the same clid going out at all times from pbx a to the co, then have the provider put that clid on all your pri's back to the carrier.. might find a work around, but that would be a very common request.. a lot of small customers have 10 trunks and one clid.. i've seen a user with 20 pris, 10K did's and one clid

john poole
bellsouth business
columbia,sc