CLAN Card 1

[dineshparikh]

I want to see the configuration of my CLAN & EPN.
But don't know how to view the conf.
We have G3si V9.

Rgds,
Dinehs

 

[colby007]

Want kind of config are you looking for? most of it is on board which doesn't allow a lot of tweaking as far as I know. I know its a 10base device that is basic routing functionality.

 

[mikeydidit]

This may be what you are after. Try "display IP-Interfaces"


Mikey

 

[dineshparikh]

That's correct Mike.
But we want to change ip address of the card and when we tried to change ip it says
"Must disable ip-interface before changing attributes"
How do u disable ip-int and what if disable it how would you connect to system and change the ip.

Dinesh

 

[bwilch]

You would have to connect to the system through a serial port. You have to disable it in order to make the changes in the same sense you have to take a trunk group out of service to modify it.

I don't recall the commands off hand, but I'll dig and see if I can find them.

 

[Rcotten]

Do a "change IP-services" then change the "Enabled" field to N.

That will stop all IP on the on the switch so make sure you are connected via a physical terminal rather than telneted into the switch.

Good luck,

Ray

 

[colby007]

you need to enter change node-names ip in that form is the IP address on the CLAN. Before you do this change ip-intefaces and disable the ethernet port, you shouldn't lose your ip connection. Then you can change the ip address of the CLAN.