CiscoSecure ACS 3.0

[kevint21]

I've installed CiscoSecure ACS 3.0 and have added in the sites for our switches and routers. I want to be able to login to these sites with a username and password i created instead of using the default cisco for username and password.

The first part works and i can login to the switch with a username but when i try to go into enable mode it wont accept the password. Any ideas?

 

[Supergrrover]

How do you have AAA setup? Can you post that part of your config?



Brent
Systems Engineer / Consultant
CCNP, CCSP

 

[kevint21]

AAA client host name = some name
AAA client ip address = 192.168.x.x
Key = kjhfsd
authenticate using = Tacacs + Cisco IOS

privilege level = 15

Question - under arguments should i have something like permit running-config

or something along these lines?
Any advice welcome. The config on the switches/routers is ok because i can login using cisco/cisco etc.

 

[Supergrrover]

Try adding this
aaa authentication enable console TACSERVER


Brent
Systems Engineer / Consultant
CCNP, CCSP