Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CiscoPro EtherSwitch 1200

Status
Not open for further replies.
oldschooln00b

oldschooln00b

IS-IT--Management
Joined
Jul 8, 2005
Messages
1
Location
US
Is there any easier way to figure out the baud rate or flow control other than testing it one by one? I have the above mentioned switch and its Grand Junction cousin FastSwitch 2800 but can't console in to either one with the standard 9600 baud, 8 data bits, no parity, 1 stop bit, no flow control. i have messed around with the settings and the most i got was this


ATQ0H0

it just rewrites this over and over on both switches
 
Sort by date Sort by votes
Take a look at this FAQ - faq558-643.

Good luck.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

gwclark
  • Locked
  • Question Question
Cisco 16 port etherswitch module
Replies
2
Views
141
vipergg
vipergg
tetote
  • Locked
  • Question Question
Cisco aironet 1200
Replies
2
Views
78
tetote
tetote
RetrogradePAK
  • Locked
  • Question Question
Help needed to setup Cisco 1200 AP
Replies
3
Views
69
burtsbees
burtsbees
volleyman
  • Locked
  • Question Question
etherswitch module in router
Replies
5
Views
237
volleyman
volleyman
bnsmhe
  • Locked
  • Question Question
Cisco 1200 acting as a repeater or bridge
Replies
0
Views
55
bnsmhe
bnsmhe

Part and Inventory Search

Sponsor

Back
Top