Cisco RV042 VPN tunnel to Kentrox Q2300

[dphoneguy24]

I think someone on here has successfully deployed a VPN tunnel between a Cisco RN042 VPN router and a Kentrox Q2300. I'm looking for some help with the settings. Getting a Phase 1 complete in the Kentrox, but that's all the further I am getting.

 

[dphoneguy24]

got it working.

 

[dphoneguy24]

FYI

Cisco RV042 settings:

Local Group Setup:
Local Security Gateway Type: IP ONLY
IP Address: (WAN static IP of this site)
Local Security Group Type: Subnet
IP Address: Local LAN subnet
Subnet Mask: Local LAN subnet mask

Remote Security Gateway Type: IP ONLY
IP Address: Remote (Q2300) Static WAN IP address
Remote Security Group Type: Subnet
IP Address: Remote LAN subnet (i.e. 192.168.100.0)
Subnet Mask: Remote LAN subnet mask

IPSEC Setup:
Keying Mode: IKE with Preshared Key
Phase 1 DH Group: DH-1
Phase 1 Encryption: 3DES
Phase 1 Authentication: SHA1
Phase 1 SA Lifetime: 28800 seconds

PFS (uncheck)

Phase 2 DH Group: DH-1
Phase 2 Encryption: 3DES
Phase 2 Authentication: 28800
Phase 2 SA Lifetime: 28800 seconds

Advanced
Keep-alive and NAT Traversal checked

Q2300 settings
Gateway (gateway name)
Remote ID Type: ipAddress
Remote Address: User Entered
Static WAN IP of RV042
Initiator Negotiation Mode: Automatic
Authentication Type: preshare key
Preshare key: same as set in RV042
DH-1
3des-sha
Lifetime format: seconds
Lifetime: 28800 secs
Enable Gateway: checked

Enable NAT Traversal - checked
UDP checksum - unchecked
Keep Alive 10 secs

Tunnel configuration
tunnel name: name
Local Address User Entered
IP Address of local LAN subnet on Q2300
Remote Address User Entered
IP Address of remote LAN subnet on RV042
Enable Tunnel checked
Transform ESP
sha
3des
noPFS
lifetime format seconds
lifetime 28800 seconds