Cisco Router set for RDP Access 1

[grasscutter]

Hello There,

Can anyone advise on what i need to do to set up outside RDP connections to internal microsoft servers.

Do is need a static translation? or can i preferably use a single outside ip address and setup port redirection.

Regards,

Derek.

 

[NettableWalker]

Hi Derek,

Just add this line to your config:

ip nat inside source static tcp 10.0.0.1 3389 xx.xx.xx.xx 3389 extendable

where xx.xx.xx.xx is the external IP address and the 10.0.0.1 is the internal server.

HTH.


MCP,CCA,CCNA, Net+, Half CCNP...