cisco 3550 smi switch configurations

[menace212]

Hello, everyone...My question is

I'm trunking between two cisco 3550 smi switches and I just enabled rip between the switches and the primary switch connects to my router....On my router I have bgp and rip configured respectively....I redistributed bgp into my rip domain and advertised the rip networks in bgp via the network command...Now when I attempt to ping a host outside of my domain, I unable to ping it...My tracert won't even get past the inital switch..I could implement a static route, but that's defeating the purpose..Any thoughts where I'm going wrong...Config's below


sw1: router rip
version 2
network 200.1.1.0
no auto-summary

sw2:router rip
version 2
network 200.1.1.0
no auto-summary

rtr: router rip
version 2
redistrubute bgp 65000 metric 2
no auto-summary


bgp 65000
network 200.1.1.0 mask 255.255.255.224
network 200.1.1.64 mask 255.255.255.224
neighbor 192.1.1.1 remote-as 65122
neighbor 192.2.2.2 remote-as 65122
maximum-paths 2


Now I'm routing a couple /27 networks on my switch, but I see them in both switch rip database and I see the routes for the bgp process plus I can see the routes in the bgp table and routing table of the router...