Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cisco 2950 switch
- Thread starter Delboy16
- Start date
----------------------------------------
Wassabi Pop Tarts! Write Kellogs today!
Here's how I configure switches out of the box, 2950's, 3500's, whatever:
1) connect the console cable to the switch and put it in my serial port on my PC.
2) use hyperterminal or whatever to connect to it.
3) type in "setup" from the command prompt
4) enter the ip and other relevant stuff.
5) then you can just telnet into it or if you have web brower software you can enter the ip address into the brower.
1) connect the console cable to the switch and put it in my serial port on my PC.
2) use hyperterminal or whatever to connect to it.
3) type in "setup" from the command prompt
4) enter the ip and other relevant stuff.
5) then you can just telnet into it or if you have web brower software you can enter the ip address into the brower.
- Status
