I have a new T1 circuit that my application vendor says needs to be bridged instead of routed to allow a forms printing server to print to my laser printers across this circuit. My problem is I have never setup bridging on cisco routers. Can someone send me a sample config or point me to a good resource? Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
cisco 1721 bridged config
- Thread starter 4given
- Start date
Check this out -->
Although this is for DSL, substitute the ATM interface for your serial (T1). Select the fist option, and it will generate the config for you. The basic things are the global commands to enable IRB, and then binding interfaces to your bridge group. Also, some things to consider is the T1, is this a point-to-point circuit between 2 offices, or an Internet T1?
Although this is for DSL, substitute the ATM interface for your serial (T1). Select the fist option, and it will generate the config for you. The basic things are the global commands to enable IRB, and then binding interfaces to your bridge group. Also, some things to consider is the T1, is this a point-to-point circuit between 2 offices, or an Internet T1?
- Status
Similar threads
- Locked
- Question