Cisco 1602 routing 2 LANs

[Guest_imported]

I recently puchased a used Ciso 1602 router to help with my study for a CCNA. I want to use it to route between two local 10 base T networks. Is this possible. The only WIC's I've seen have been for connecting to a T-1, ISDN, DSL, etc. Can I find a card to use or possibly use one of the existing terminals for my "WAN" interface? Any help would be great. Thanks

 

[jspuelles]

Sorry Jp1600, I dont understand your problem, but I´ll try to answer that I think: 1.- if you want route 2 local LANs with only one eth port: add secondary address to this port. 2.- If you want route 2 LANs through serial port you need other router connected with DTE-DCE cables.
I don´t know if this solve your problem

Regards

Rantas303