CID on 824??

[NiceRing]

I am working on an old 824/DR5 ksu. my customer wants CID. I know I can't put CID on the first 8 lines, but I thought I could install a couple of CID cards in a 12X0 module and just program those lines in place of the first 8. It doesn't appear that the programming is available for CID. There are a couple of things about call logs and name first, but that is all I see. I don't see a way to make the sets have CID. I think I may have mis-led my customer inadvertently. What say you gurus out there?

 

[Brutalis]

You can have cid on the 1st 8 lines of an 8X24 KSU if you use an M8 module. The programming is under GEN ADMIN / Call Services.

 

[norstarboy125]

It will be cheaper to get a couple CI cards if you have a 12x0 in place, those M8's are pretty expensive. You will just get auto caller id info on one set, the rest can use f 811 or just answer then see clid.

Jeremy J. Carter
Charm City Communications

http://www.charmcitycommunications.com

Norstar. BCM. CS1000 Programmer

 

[GordonKapesMZ4]

I have an M8 sitting in my basement....and its punched down to a 66 block already for line 1....

Joseph Sus-Nortel Installer/Programmer

http://www.linkedin.com/pub/joe-sus/12/1a7/856

 

[curlycord]

My condolence's

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[GordonKapesMZ4]

Why condolences? I should sell that thing, it goes for $300 on ebay, instead it's sitting in a box. I am using a BCM and UCx50 Emetrotel switch now....

Joseph Sus-Nortel Installer/Programmer

http://www.linkedin.com/pub/joe-sus/12/1a7/856

 

[curlycord]

lol I thought it was in use....the whole 66 block thing too, so primitive.





=----(((((((((()----=
curlycord

http://www.curlycord.com