Is there something special that needs to be set to get the CID working. I've verified setting and everything looks correct. The only thing that shows up on the display is the number that I called(DID). AT&T says that they're sending it but has never had a tech on site to verify it. Outbound CID seems to be working correctly. Thanks in advance.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
CID from a PRI on MICS with 4.1
- Thread starter warnp
- Start date
SupportDude
Technical User
There is a setting under the Target Line configuration that allows you to specify the set that should receive CLID for that particular Target Line.
Go to Lines and do a SHOW.
Input the Target Line number and do a SHOW.
Go NEXT until you come to CLID Set.
Make sure this matches the set the line rings on.
-SD-
Go to Lines and do a SHOW.
Input the Target Line number and do a SHOW.
Go NEXT until you come to CLID Set.
Make sure this matches the set the line rings on.
-SD-
- Status
Similar threads
- Locked
- Question
- Locked
- Question