dmoore7648
IS-IT--Management
Anyone know how to change the SNMP community string on a G700? The default is “Public” and I need to change it for obvious reasons.
Thanks!
Thanks!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Changing SNMP Community String on G700
- Thread starter dmoore7648
- Start date
- Status
I have changed the comm string, off the top of my head I can't remember the command. You could do the following
On the MGP set snmp help this will give you all of the commands available to set snmp parameters.
You can also set the snmp parameters for the stack using the same commands.
On the MGP set snmp help this will give you all of the commands available to set snmp parameters.
You can also set the snmp parameters for the stack using the same commands.
charmstrong
Vendor
Hi, the commands you are looking for is:
set snmp community xxxx - and then do a help for ro/rw/trap (I think it readonly, readwrite, trap).
Hope this helps
set snmp community xxxx - and then do a help for ro/rw/trap (I think it readonly, readwrite, trap).
Hope this helps
- Status
Similar threads
- Locked
- Question
- Locked
- Question