Change the order of output of an analog trunk card at BCM 400

[Aerap87]

Hello
Good day.

I wonder if it is possible to change the order of output of an analog trunk card at BCM 400. Always to use the calls via analog trunk, where it uses the last channel and the credits of this chipcel stem always ends before the others.

 

[curlycord]

Always to use the calls via analog trunk, where it uses the last channel and the credits of this chipcel stem always ends before the others."

I wish I could understand what the hell you just said but sadly I cant sorry.

Lines in a pool will always use the bottom lines first.




=----(((((((((()----=
curlycord

http://www.curlycord.com

Toronto Canada

http://www.telcopc.ca

 

[Aerap87]

What I want to know if it is possible to switch channels within the pool.

 

[QueBall780]

That's a wiring problem, not a programming problem.

Just change the order of the wiring to match what you want. It should match the order of the ring group the Telco has given you so that incoming calls come in starting with the lowest numbered lines and outbound calls start with the highest.

But really what is the point? Usually one line is as good as another, there shouldn't be any difference.

 

[curlycord]

There is no wires for "Channels" though?

Do you have a PRI or Analog Trunks?
Anologs uses Ports
PRI uses Channels



=----(((((((((()----=
curlycord

http://www.curlycord.com

Toronto Canada

http://www.telcopc.ca