Catalyst 2950 1

[demea26]

I'm new to the 2950 switch, which I got a great deal on and is the reason I bought it. I'm migrating from an unmanaged 3com 24 port. The question that I had is that I set up the switch using the express setup, configured the IP address, hostname, passwords, etc. and I have no connectivity from the other 23 ports. Just the first port which is the default VLAN1. What needs to be done in order to use this just as a switch and no VLANs.
Thanks

 

[dx1]

Check to make sure all the ports are on the same vlan and they are not shutdown. Is this a brand new switch or is it used? If new, should be able to just plug and go...if it's used, it might have been pre-configured with different vlans. If you can, post the config.

 

[demea26]

Its a brand new out of box switch. Should I erase the current config then?

 

[demea26]

Heres the current config.
Ports 5-24 are the same, but I didnt copy them:
Thanks

Vlan1 is up, line protocol is up
Hardware is CPU Interface, address is 000f.24bc.43c0 (bia 000f.24bc.43c0)
Internet address is 192.168.10.30/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 4000 bits/sec, 6 packets/sec
5 minute output rate 10000 bits/sec, 5 packets/sec
124803 packets input, 9866478 bytes, 0 no buffer
Received 44267 broadcasts (0 IP multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 43 ignored
157543 packets output, 31922776 bytes, 0 underruns
0 output errors, 4 interface resets
0 output buffer failures, 0 output buffers swapped out
FastEthernet0/1 is up, line protocol is up (connected)
Hardware is Fast Ethernet, address is 000f.24bc.43c1 (bia 000f.24bc.43c1)
MTU 1500 bytes, BW 100000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 4000 bits/sec, 5 packets/sec
5 minute output rate 10000 bits/sec, 5 packets/sec
174779 packets input, 15025081 bytes, 0 no buffer
Received 48679 broadcasts (0 multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 4413 multicast, 0 pause input
0 input packets with dribble condition detected
157540 packets output, 32428204 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
FastEthernet0/2 is down, line protocol is down (notconnect)
Hardware is Fast Ethernet, address is 000f.24bc.43c2 (bia 000f.24bc.43c2)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto-speed
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 1d01h, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
1 packets input, 64 bytes, 0 no buffer
Received 0 broadcasts (0 multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
1 packets output, 64 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
FastEthernet0/3 is down, line protocol is down (notconnect)
Hardware is Fast Ethernet, address is 000f.24bc.43c3 (bia 000f.24bc.43c3)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto-speed
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 1d01h, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
1 packets input, 64 bytes, 0 no buffer
Received 0 broadcasts (0 multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
1 packets output, 64 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
FastEthernet0/4 is down, line protocol is down (notconnect)
Hardware is Fast Ethernet, address is 000f.24bc.43c4 (bia 000f.24bc.43c4)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto-speed
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 1d01h, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
1 packets input, 64 bytes, 0 no buffer
Received 0 broadcasts (0 multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
1 packets output, 64 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out

 

[demea26]

I erased the current config by holding down the mode button. Now, I know the default ip address of the switch is 10.0.0.1, does that mean if I make no changes to the switch and just plug and play, my network ip scheme needs to be changed as well? Just curious

 

[vipergg]

The ip address for the switch is for management only . As long as all the ports are in the same vlan and your clients are addressed in the same subnet range they should be able to talk to each other , the switch would have to be addressed in the same subnet range in order to telnet to it and manage it , otherwise your only management will bee thru the console port .

 

[demea26]

This is odd. With any other switch that I had used, you just power it up and plug in node ports and done, networked!
The only port lit up is #1, too. If I plug a cable into another port, 2-24, nothing.
What gives?
Thanks for all your time, guys

 

[demea26]

Duh. I had the far jacks wired for B and the patch panel wired for A. Doh!
Too much on my mind I guess...
Thanks guys

 

[Lequang]

version 12.1
no service pad
service timestamps debug datetime localtime
service timestamps log datetime localtime
service password-encryption
!
hostname ????????
!
enable secret ??????
!
ip subnet-zero
no ip domain-lookup
!
!
spanning-tree mode pvst
no spanning-tree optimize bpdu transmission
spanning-tree extend system-id
spanning-tree uplinkfast
spanning-tree backbonefast
!
!
interface FastEthernet0/1
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/2
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/3
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/4
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/5
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/6
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/7
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/8
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/9
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/10
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/11
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/12
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/13
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/14
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/15
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/16
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/17
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/18
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/19
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/20
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/21
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/22
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/23
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface FastEthernet0/24
switchport access vlan 150
switchport mode access
no ip address
spanning-tree portfast
!
interface GigabitEthernet0/1
description === connection to Charly-1 ===
switchport mode trunk
no ip address
!
interface GigabitEthernet0/2
description === stack-port to G19_03_02 ===
switchport mode trunk
no ip address
spanning-tree stack-port
!
interface Vlan1
description === Management ===
ip address x.y.z.w 255.255.255.0
no ip route-cache
!
no ip http server
!

line con 0
line vty 0 4
password ??????
login
line vty 5 15
password ??????
login
!
ntp clock-period 17180031
ntp server a.b.c.d
end