Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

cat3524 Commander and member IP change 1

Status
Not open for further replies.
funnyface

funnyface

MIS
Dec 8, 1999
6
US
Is there an easy way to Change the IP address and VLAN of the command switch without breaking the member switches from the link. When I changed the IP address and Vlan I lost communication between the member switches. I can see them but they display as down.

Thanks
 
Sort by date Sort by votes
It sounds like you changed the management vlan 1, which (if true) is why you lost the communication from the other switches. By default, vlan 1 is the management vlan for all Cisco switches and all vlans. Of course, you'll need a (CISCO, is there any other :>) router to get to the other vlans. Remember also, switches are layer 2 devices and do not understand IP (layer 3) addresses. It does use an IP address (telnet management) but that's about all.
Frank
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

B
  • Locked
  • Question
Cisco IP phone 7841 8851 unable to forward all to external number
Replies
0
Views
215
badwolf1686
B
CPM86
  • Question
Cisco isr 4331 with IOS and sip busy fail over to 2nd sip number on pbx?
Replies
0
Views
320
CPM86
CPM86
jobsp90
  • Question
I have a issue in my office hospital network regarding using IPPBX software.
Replies
2
Views
239
DavetheChef
DavetheChef
Lccarter
  • Locked
  • Question
Cisco CUCM Provisioning and Order Management System
Replies
1
Views
391
Lccarter
Lccarter
melhabba
  • Locked
  • Question
HOW to change display name
Replies
0
Views
228
melhabba
melhabba

Part and Inventory Search

Sponsor

Back
Top