Cant TTI

[MadAccess]

I lost the ability to TTI after an upgrade. Now I plug a phone in and it stays dark (no dial tone, no lights) until I assign a port in ASA. Something changed but I dont know what. Any ideas?

CM 3.1.4

 

[SF0751]

CHA SYS FEA"; make sure that TTI is enabled and that the TTI state is set to "voice".

Susan
"When the gods wish to punish us, they answer our prayers." - Oscar Wilde, An Ideal husband, 1893

 

[MadAccess]

It is. Enabled = y, TTI State = Voice. And I can still TTI at the main site and other remote sites. It's just this one site now that cant do it.

 

[Mitch672]

I have had this happen before, try disabling TTI, then "status tti" until its all off, then re-enable TTI (change sys features), see if that helps

Also, make sure the remote gateway is registered to the main switch (list media) will show you..

Mitch


AVAYA Certified Specialist

 

[MadAccess]

I never tried that Status TTI command before. I'll do that. Thanks!