can't do phantoms? 3

[gagz]

does this section of the configuration record imply that i can't create phantoms?

CEQU
MPED 8D
SUPL 000 004 008 012
016 032 036 040
044 048 064 068
072
XCT 000
CONF 029 030 031 062
094 095

DLOP NUM DCH FRM TMDI LCMT YALM T1TE TRSH
PRI 01 23 ESF YES B8S FDL 0 00
02 23 ESF NO B8S FDL - 00
MISP
OVLY

I know i can on my 61c in my other office, i'm working on an option 11c in this office...

thanks.

 

[Reusser]

no - you can on option 11 you just do it a little different

LD 97
req: chg
Type: supl
supl: n96

phantom loop is built on 96
build ports on cards 61, 62, 63, and 64

if you need another phantom loop build on 100 and then cards are built on 65, 66, 67 and 68

 

[NorstarOption]

What about for Opt61c and Opt81c which superloops should I program first. And up to how phantom loops can you have?

 

[Reusser]

61 start at loop 156 and work towards loop 32
81 start at loop 252 and work in same direction

you will run out of liscence before you run out of available ports

 

[NorstarOption]

61 and 81 matches the phantom you program? So your first phtn is 156 0 0 0?

 

[gagz]

Reusser-

I did what you suggested, seemed to add the loop (the configuration record shows P096 now). When i go into ld 10 and try to add a new 500 set, as soon as i type (for tn) 96<space>, i get a loop out of range error.

any ideas?

 

[johnpoole]

try 2616 as opposed to 500? i don't do phantoms due to the cost of lic. 99 percent of them can be built free in other loads.. i had 400 phantoms built wheni got here, 3 months later i had them all reprogramed except 3, and they are used for rcfw only

john poole
bellsouth business
columbia,sc

 

[Nortellian]

i think reusser's advice was build the phantom loop of 96 and program tn's on 61,62,63,63. so try 61 0 at the tn prompt.

 

[NorstarOption]

Yes opt11 is weird, when you build phantom 96, you're activating loops 61, 62, 63 and 64.

 

[johnpoole]

right i should have know that? seems like when you screw a switch to a wall it thinks it's a key system...

john poole
bellsouth business
columbia,sc