Cannot Telnet to my Pix 1

[mRgEE]

I have a Pix 501. I have assigned the outside interface with an ip address of 10.0.0.253 255.0.0.0.

I get a reply when I ping this pix ip address from my LAN. However I cannot telnet into the pix. This is something I really need. Any Ideas?

My configuration is shown below: -

PIX Version 6.2(2)521
nameif ethernet0 outside security0
fixup prot
nameif ethernet1 inside security100
names
pager lines 24
enable password ####### encrypted
interface ethernet
passwd ######## encrypted
mtu outside 1500
hostname CP501FW

fixup protocol smtp 25l (outside) 1 interfac
fixup protocol sqlnet 1521
nat (inside) 1 0.0.0.0
fixup protocol sip 5060
t
fixup protocol skinny 2000
timeout con
names:00 h
pager lines 24:00 udp 0:02:0
interface ethernet0 10baseti
interface ethernet1 10full
mtu outside 1500edia 0:02:00
mtu inside 1500
timeout
ip address outside 10.0.0.253 255.0.0.0
aaa-server TACACS+ protoc
ip address inside 192.168.1.1 255.255.255.0
aaa-server RADIUS protocol radius
aaa-server TACACS+ protocol tacacs+
aaa-server RADIUS protocol radius
aaa-server LOCAL protocol local
http server enable
http 192.168.1.0 255.255.255.0 inside
no snmp-server location
no snmp-server contact
snmp-server community public
no snmp-server enable traps
floodguard enable
no sysopt route dnat
telnet 10.0.0.0 255.0.0.0 outside
telnet 10.0.0.0 255.0.0.0 inside
telnet timeout 5
ssh timeout 5
dhcpd address 192.168.1.2-192.168.1.33 inside
dhcpd lease 3600
dhcpd ping_timeout 750
dhcpd auto_config outside
dhcpd enable inside
terminal width 80
Cryptochecksum:435f28960d5afb0fdc323bf972cb7058
: end
CP501FW#

 

[colinT23]

Hi,

You can't Telnet into the Outside interface of a PIX as Telnet is insecure. If you need external access, use SSH.

Regards Colin.