Cannot remove TN2602 from the switch

[Maya97]

I am trying to remove an EPN from a MCC cabinet, I was able to remove other boards however when I still show no board. I have added the boards back to the switch and nothing happens I disable the ethernet and then remove the ip-interface and I still show this when I do li config port network. PLEASE HELP!!

SYSTEM CONFIGURATION

Board Assigned Ports
Number Board Type Code Vintage u=unassigned t=tti p=psa

07B01 TONE/CLOCK no board
07B19 IP MEDIA PROCESSOR no board u u u u

 

[dufus2506]

Try this command:

change circuit-packs <cabinet-number>

This may help you remove them from programming.

Carpe dialem! (Seize the line!)

 

[Maya97]

I tried that and still have the no board listed. Should I actually remove the board from the cabinet?

 

[dufus2506]

I think you have to remove the board before you use the change circuit-packs command.

It's been a while since I've removed an EPN...

Carpe dialem! (Seize the line!)

 

[Maya97]

Let me try that would that also affect the tone/clock also?

 

[dufus2506]

I'm not sure.

The tone/clock card can be inserted into only one slot. The system assumes that it's where it is, and it really can't be removed.


Carpe dialem! (Seize the line!)

 

[AvayaTier3]

no board conditions means that the carrier / board does not see a circuit pack. If a complete carrier or cabinet shows this, you can remove all programming from the boards, then use change circuit-pack x (where "x" is the cabinet number)
blank out the boards and submit.

all programming includes anything related to the board or ports on the board. If you cannot blank out a pack within the change circuit-pack x form, then you have not removed all the associated programming for that board.

After all slots on all pages of change-circuit x are blank, you can remove the cabinet.



A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

35 years Bell, AT&T, Lucent, Avaya
Tier 3 for 25 years and counting

http://bshtele.com

 

[Maya97]

Ok I was able to remove it from circuit change-circuit x but it still shows

SYSTEM CONFIGURATION

Board Assigned Ports
Number Board Type Code Vintage u=unassigned t=tti p=psa

07B01 TONE/CLOCK no board
07B19 IP MEDIA PROCESSOR no board u u u u

what could be the problem? Am I missing something?

 

[PBXTech]

busy the fiber link, remove the fiber link, remove the cabinet.

what is the switch telling you when you try to run these commands? is this an S8700 or a G3r?

 

[AvayaTier3]

change circuit-pack 7 and these will be on page 2.

once removed, list config will not show them any longer.



A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

35 years Bell, AT&T, Lucent, Avaya
Tier 3 for 25 years and counting

http://bshtele.com

 

[Maya97]

That did the trick...it was on page two...thanks for your help.