Can this unit handle 1 card more? LDK 300 2

[teomcam]

My system has LG ARIA 300 and slots order as below;

LDK-300 PSU
Slot 1TIB24
Slot 2TIB24
Slot 3TIB24
Slot 4TIB24
Slot 5:SLIB12
Slot 6:LCOB8
Slot 7:Empty
Slot 8:WTIB
Slot 9:MISB
Slot10:MPB

Can this system handle 1 VMIB card?

 

[doktor]

The ipLDK-300 can handle 9 slots pr cabinet, so in the SLOT=7, you should be able to put a VMIB (or VMIBE) board.

///doktor

 

[teomcam]

I think there is some points because I can not use 5th DTIB card (already reached max number 96) or another SLIB12 card. Units says Highway full something as I remember. I was wondering if I buy VMIB card will it handle. I dont wanna sucrifice DTIB or WTIN. I can get rid off MISB because pratically I dont use.
So my iam is putting VMIB card but I am not sure if this system handle it.

 

[doktor]

The system will handle it because VMIB does not count in the Extension and CO line "numbers".

///doktor

 

[doktor]

LDK-300 PSU
Slot 1TIB24 - takes 24 "time slots for extensions".
Slot 2TIB24 - takes 24 "time slots for extensions".
Slot 3TIB24 - takes 24 "time slots for extensions".
Slot 4TIB24 - takes 24 "time slots for extensions".
Slot 5:SLIB12 - takes 12 "time slots for extensions".
Slot 6:LCOB8 - takes 8 "time slots for CO lines".
Slot 7:Empty
Slot 8:WTIB - takes xx "time slots for extensions".
Slot 9:MISB
Slot10:MPB

The maximum number of extension is 96 in one cabinet.
The maximum number of CO lines is 120 in one cabinet.

So, I think you need one extra cabinet to handle the SLIB12 and the DECT part (WTIB).

Do you have some problems with this system?

///doktor

 

[SteveBUK]

Hi gents,
1st Cab of ipLDK 300 support 96 stations.
Max number of time slots is 144, but 12 are resvered, so max time slots are 132.

As the doctor has said, the ports/time slots of the WTIB will depend on the number of stations assigned to it and If there is a WTIU.
WTIB with 8 stations = 8 time slots
WTIB with 16 stations = 16 time slots
But WTIB with more than 16 stations is still 16 time slots.

If you keep the existing config and add a VMIBE (4 Channel)- which takes 4 ports and 5 time slots you will need a 2nd cab

Regards
Steve

 

[teomcam]

H? Guys,

Thanks very much for these valuable informations.
Existing system with the confguration that Ive mentioned above working fine. Additionally;

WTIB has 16 extension

and according to your calculations all already came up to 132 time slot so I will need to buy second KSU.
What about if reduce the WTIB extension to 8 only (not much people using rightnow) I think I can place WMIB, right?

 

[SteveBUK]

Hi Guys,

The 1st cab should only have 96 stations.
I would use a 2nd cab

 

[tarikkk]

Hi guys
Even if the 1st cab can handle only 96 or 132, you can use more extensions, the only problem is that all 96 or all 132 will not speak at same time (which is not very probable)!!!

 

[teomcam]

Hi Tar?k,

But when I put excessive card receiving an error and it was saying highway full something.
As I know even you have 2 cabs LDK will allow max of 96 simultaneous calls.

 

[tarikkk]

No in my knowledge it allows less than that .
That's why we add DTRU daughter boards to allow more communications
But I didn't see any problem adding boards even if we pass 96 extensions