CAN´T BRAKE THE " ROUTER (BOOT)# " PROMPT

[Guest_imported]

ANY BODY CAN HELP ME WITH THIS??..I HAVE A 2500 ACCESS SERVER WITH THIS PROMPT: Router(boot)# THAT NOT LET ME TO DO BASICS COMMANDS SO I TRIED SEVERAL TIPS AND NOTHING...THANKS A LOT

 

[tiremd]

The router has booted off the bootroms to get that prompt, not the flash...

do a 'sho flash' to make sure you have a valid image...
If so, then do:
config t
config-register 0x2102

and then reset, this will tell the router to boot and load the image from flash...

has to be a valid image thought with a good checksum...

 

[Guest_imported]

Thanks Tiremd, but what i I can`t do the " sw flash" because that command don`t exist in this prompt. It`s mean tha i have a no valid flash??..I already try to make the config-reg but it`s the same thing...another idea??..Thanks

 

[Guest_imported]

Thanks Tiremd, but what i I can`t do the " sw flash" because that command don`t exist in this prompt. It`s mean tha i have a no valid flash??..I already try to make the config-reg but it`s the same thing...another idea??..Thanks

 

[Guest_imported]

Thanks Tiremd, but what i I can`t do the " sw flash" because that command don`t exist in this prompt. It`s mean tha i have a no valid flash??..I already try to make the config-reg but it`s the same thing...another idea??..Thanks