Calls from Overseas

[CaperJ]

Any ideas on a call from overseas not able to call into a pri that trombones tp a qsig link. All local and LD calls are ok only calls from overseas. They get intercepted to the console. My programming is in my other post on the same subject.

 

[johnpoole]

are the oversees calls coming in on your normal ld trunks? that would rule out trunk to trunk blocks.. trmb helps when a call comes from the tdm and is forwarded back to the tdm, other then that it should not be a problem.. i have the same setup here but have not had that problem with my qsig.

john poole
bellsouth business
columbia,sc

 

[CaperJ]

I have tromboning on as and it works from LD and local just not overseas calls.

 

[CaperJ]

Sorry yes coming in on same trunks as all other calls.

 

[johnpoole]

trmb does not look at the calling number? there has to be another factor. calls from overseas do not ring the far end of the qsig, or do they fail on forward from the qsig back to the 81? if that's the case i would match the ncos of the inbound to the ncos of the qsig and test it... i still can't find a link between the calling and this problem. where in the switch can i turn off international to a unique route? you may be needing a patch written.. if you can't block that call on a working trunk based on calling number then that would make me think that you can't remove a block.. push this one to nortel support, not very likely that your the 1st one to see this problem.. i tested my qsig from ld before i turned it up to service, but i can't say for sure that international calls worrk to that link.. my qsig is going to a ccm (cisco) and that only has wireless sets that are mostly used as a fdn..

john poole
bellsouth business
columbia,sc

 

[jgideon]

Are the trunks PRI? I'd take a look at the bearer service...

 

[CaperJ]

Which Promp VRAT ?