I have 3 hard drives in a raid configuration that I can load CP 2.0 and 5.0 - and change the firmware on the card to accomodiate. I need to load CP 4.0 and when I am going to load it, using the ghost software - it fails right after it should start loading - leaving the already installed CP 5.0 completely available. Any thoughts?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Callpilot 4.0
- Thread starter mylizard
- Start date
Similar threads
- Locked
- Question
- Locked
- Question