Calling extension to extension between LIK600 & LIK300

[nightwolf91]

Good day all,

From what I've been told you do not need a license to call extension to extension between LIKs.

I have tried setting this up in the networking data program. I have voip trunks at each LIK.
At pgm 324 I have CPN information ip address as the voim at the other LIK and the MFIM(E)as the firewall ip address of the other LIK.
I am using table index #1 in pgm 324 and I have put my voim trunks in networking co group 1.
I have net enable on in pgm 320 and I have system usage set to net in pgm 324.

I get 'no route to destination' when I dial an extension number of the other LIK. Obviously my programming is not complete.
I am wondering if anybody has any information where I should look next.

Thanks for any help.

nightwolf

 

[xs650]

Do you have a networking license in both systems, cause otherwise it is not possible to set
PGM320 NET enable=ON ?

 

[nightwolf91]

Yes ...both LIKs allow me to turn Net enable to on in PGM 320.

 

[xs650]

When you can enable it you must have a networking license or the trial time is running.

Here is a shortform what you have to do in both systems:
-PGM140-142: program all IP trunks in one CO group and set the type to DID
-PGM117: the stations should have access to the used CO group
-PGM320: activate Net enable
-PGM322: program the used IP trunks in THE SAME group like in PGM140-142 and set the type to NET
-PGM324: here you set which numbers are routed to the other systems. When in the other side all stations from
200-299 are located set:
System Usage = NET
Numbering Plan code = 2**
Networking CO group = the CO group that is programmed in PGM 140-142 AND PGM322
CPN information 1 = IP address of the other system

When you now dial 200 the call is routed to the other system.

 

[nightwolf91]

Thank you for your help xs650.
I'll give it a try.

nightwolf

 

[doktor]

You will find a good "how-to-di-list" here: thread1613-1484626
It is ipLDK's,but the principles are the same.
Remember to install networking licenses!

///doktor
____________________________________

http://www.kandu.dk/spg153996.aspx

 

[nightwolf91]

Thanks doctor.
I have to put this project on hold for the time being. When I get it working I will report back how it went.

Thanks everyone who took the time to reply.
Very much appreciated.

nightwolf

 

[doktor]

Thanks for your status update.

///doktor
____________________________________

http://www.kandu.dk/spg153996.aspx