Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Caller ID
- Thread starter met566
- Start date
Have you gone into the sets where the lines ring, under telco features, feature assignment and turned on CID per line? After that in the same menu, set called ID to yes to see the CID before answer.
Jim
"If I had known it would turn out like this, I would have became a locksmith" Albert Einstein
NCSS NCTS NCTE
Mitel 3300 4.2 basic & advanced, 5000 4.0
Jim
"If I had known it would turn out like this, I would have became a locksmith" Albert Einstein
NCSS NCTS NCTE
Mitel 3300 4.2 basic & advanced, 5000 4.0
allworxguy
Vendor
If you have software version 6.1 or higher you can program caller ID to auto display at any extension on which the lines Appear & Ring. Look under Terminals & Sets/Telco Features/Feature Assign. Then allow caller ID for each line that Appears & Rings. Also look under Terminals & Sets/Telco Features and change 1st Display from Name to Number.
If you have any software version lower than 6.1 you can only get caller ID to auto display at one extension per line. All others can use F811 to see caller ID before answering a call. Caller ID should display to any phone after answering a call.
Brian Cox
Oregon Phone
If you have any software version lower than 6.1 you can only get caller ID to auto display at one extension per line. All others can use F811 to see caller ID before answering a call. Caller ID should display to any phone after answering a call.
Brian Cox
Oregon Phone
- Status
Similar threads
- Locked
- Question
- Locked
- Question