Caller ID on R1T1

[Serenitynow109]

Hey Everyone;

I read the compatability matrix and think I am correct in my assumption but wanted to take it to the pros for clarification.

I cannot use a CLID card on R1T1 software, correct? Which means no Caller ID until release 4?

All assistance appreciated as always..

"The Phone man did it

 

[lugerlover]

NA CI Trunk Card (NT5B41GA/GB) compatible to r1t1..will only show on clid set was fixed on 4 "i think

 

[exsmogger]

On MICS you could only have caller ID auto display at one set per line. It can be the same set for all lines. All others must use F811 to see caller ID before answering a call. This was fixed in R6.1.

Brian Cox

http://www.jandjcommunications.com

 

[RikRodgers]

That's always been a thorn in the side for our customers with older sw, but they rarely want to spend the cash to upgrade.