Call pick up BP50!

[rfpup]

I am trying to configure two IP phones 422 02 in a call pick up group.
PBX sw is BP16 R3B and the software in IP phones the last one.

1. via command 5614 I have created call pickup code
2. under parameters of the created call pickup code; under call pick up group 0, parameters, I have added two DIR numbers of IP phones.
3. via command 2403 I have putted 8
4. in the config file of IP phones I have configured the same:CallPickUp=8

I am calling in one of the IP phones and pressing 8 at the other one ang can not pick up call.

Any idea if I need to see something else?

Thank you

 

[rfpup]

I found it

Call pick up code have to be 8 also.