I have a option 81 running 5.0 software. I had a new patch loaded on the pbx to correct issues with DST. NORTEL instructed the tech to install a new deptlst, this contain around 200 patches including the DST patch. In the morning I started getting BUG105, and BUG365. This caused a lot of static on the PRIs. Once I removed the new deplst the problem went away. Any suggesting?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
BUG105 BUG365
- Thread starter glynnmsg
- Start date
Since Nortel is working with Tech - have teck report to Nortel..
could be a defective patch:
may be patch - MPLR24808
BUG105 against channels with VGW(Voice Gateway) PTNs(Physical TN) *** NOTE: THIS PATCH IS NOT APPLICABLE TO MACH TYPE: SSC ***
or MPLR24161
BUG387 BUG365 BUG4030 printed during manual SYSLOAD
or MPLR25638
BUG365 related to PCA over virtual trunk calls
or MPLR26250
Speechpath setup fail by Call Server causes CCMS (SYMPOSIUM - CONTACT CENTER) ACD acquired ports / agents go NRD (NOT READY). Also BUG365 may be printed.
All those patches are part of Deplist. could add patches back and remove one of these at a time to see if clears.
could be a defective patch:
may be patch - MPLR24808
BUG105 against channels with VGW(Voice Gateway) PTNs(Physical TN) *** NOTE: THIS PATCH IS NOT APPLICABLE TO MACH TYPE: SSC ***
or MPLR24161
BUG387 BUG365 BUG4030 printed during manual SYSLOAD
or MPLR25638
BUG365 related to PCA over virtual trunk calls
or MPLR26250
Speechpath setup fail by Call Server causes CCMS (SYMPOSIUM - CONTACT CENTER) ACD acquired ports / agents go NRD (NOT READY). Also BUG365 may be printed.
All those patches are part of Deplist. could add patches back and remove one of these at a time to see if clears.
- Thread starter
- #3
- Status