Is there an issue with using a bit datatype for a selection criteria in CR 8.5? I do not remember using one before. But, I am doing it in this report. It works fine from within CR. But, when I launch it from VB6 I get an error "..False is an unknown column name". The VB code makes no reference to the column. I tried setting the value to 0, which I would normally do in VB. But CR will not accept it. I do not find any discussion about this, so I am rather perplexed.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Bit/Boolean SQLServer/Crystal 8.5
- Thread starter demoman
- Start date
Similar threads
- Locked
- Question
- Question
- Locked
- Question
- Locked
- Question