Loggs from after an crash or reboot todyay oct. 27...
router#show version
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3640-JK9O3S-M), Version 12.2(19a), RELEASE SOFTWARE (fc2)
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Mon 29-Sep-03 23:45 by pwade
Image text-base: 0x60008930, data-base: 0x615DA000
ROM: System Bootstrap, Version 11.1(7)AX [kuong (7)AX], EARLY DEPLOYMENT RELEASE SOFTWARE (fc2)
router uptime is 43 minutes
System returned to ROM by power-on
System restarted at 17:55:22 CDT Wed Oct 27 2010
System image file is "flash:c3640-jk9o3s-mz.122-19a.bin"
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
If you require further assistance please contact us by sending email to
export@cisco.com.
cisco 3640 (R4700) processor (revision 0x00) with 125952K/5120K bytes of memory.
Processor board ID 05247830
R4700 CPU at 100Mhz, Implementation 33, Rev 1.0
Channelized E1, Version 1.0.
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
Primary Rate ISDN software, Version 1.1.
1 FastEthernet/IEEE 802.3 interface(s)
4 Serial network interface(s)
2 Channelized E1/PRI port(s)
2 Channelized T1/PRI port(s)
DRAM configuration is 64 bits wide with parity disabled.
125K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
router#show environment all
Power Supply:
Redundant Power System is not present.
Board Temperature:
normal.
router#show logging
Syslog logging: enabled (0 messages dropped, 0 messages rate-limited, 0 flushes, 0 overruns)
Console logging: level debugging, 26 messages logged
Monitor logging: level debugging, 0 messages logged
Buffer logging: level debugging, 26 messages logged
Logging Exception size (4096 bytes)
Trap logging: level informational, 30 message lines logged
Log Buffer (20000 bytes):
00:00:14: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
00:00:15: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, chang ed state to down
00:00:15: %LINEPROTO-5-UPDOWN: Line protocol on Interface Multilink1, changed st ate to down
00:00:16: %LINEPROTO-5-UPDOWN: Line protocol on Interface Multilink2, changed st ate to down
00:00:16: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel0, changed state to down
00:00:16: %SYS-5-CONFIG_I: Configured from memory by console
00:00:16: %LINK-3-UPDOWN: Interface Serial0/0:0, changed state to down
00:00:16: %LINK-3-UPDOWN: Interface Serial0/1:0, changed state to down
00:00:16: %LINK-3-UPDOWN: Interface Serial0/2:0, changed state to down
00:00:16: %LINK-3-UPDOWN: Interface Serial0/3:0, changed state to down
00:00:17: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0:0, changed s tate to down
00:00:17: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/1:0, changed s tate to down
00:00:17: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/2:0, changed s tate to down
00:00:18: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/3:0, changed state to down
00:00:18: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3640-JK9O3S-M), Version 12.2(19a), RELEASE SOFTWARE (fc2)
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Mon 29-Sep-03 23:45 by pwade
00:00:18: %SNMP-5-COLDSTART: SNMP agent on host router is undergoing a cold start
00:00:18: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
00:00:25: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel0, changed state to up
00:00:29: %CONTROLLER-5-UPDOWN: Controller T1 0/1, changed state to up
00:00:30: %CONTROLLER-5-UPDOWN: Controller T1 0/0, changed state to up
00:00:30: %LINK-3-UPDOWN: Interface Serial0/1:0, changed state to up
00:00:30: %LINK-3-UPDOWN: Interface Multilink1, changed state to up
00:00:31: %LINK-3-UPDOWN: Interface Serial0/0:0, changed state to up
00:00:31: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/1:0, changed state to up
00:00:31: %LINEPROTO-5-UPDOWN: Line protocol on Interface Multilink1, changed state to up
00:00:32: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0:0, changed state to up
router#
matt