Bell number to ring @ stations

[phonedud]

We are going to smart trunks Pri and have serval old Bell number that need to ring a one station. Can some one tell where this table information will be so I can start to input the information. Thanks

 

[DAVIDPAYNE]

What do you mean when you say several old bell numbers?
Also what reversion of the system are you working on?

 

[phonedud]

CM 2 I think Old bell number that went to a standalone station

 

[DAVIDPAYNE]

Are this number going to come in on the new PRI and if so how many digits is the carrier sending?

But basically look at the "change inc-call-handling-trmt trunk-group x" where x is the trunk group the number ride over.

 

[phonedud]

did not find anything listed there. I have a number 231-2700 that when it is called it ring at ext 285 in our system and I need to change that station number. Some where there is a table for this information.

 

[DAVIDPAYNE]

That is what I gave you. You have to know what trunk group the number comes in own, and how many digits and what digits there are sending. Once you know that, you can use the "change inc-call-handling-trmt trunk-group x" to change those number to what ever you need.

If your number 231-2700 rings to ext 285, then ether the carrier is sending you 285 for that number or it is being translated some where. Normal that is done on the "inc-call-handling-trmt trunk-group" table. there are a few others whys to do that. But I would 1st check with the carrier and see what they are sending you, and make sure it is coming in on the trunk group you think it is coming in on.

 

[phoneguy55]

in CM2, I believe incoming call handling was in the trunk group.