Jackmetickler
MIS
Backup Exec 10d SBS2000 - HP Ultrium 230
Whenever I apply an update - I have just installed SP3 -
Backup exec fails to communicate with drive. Presumably the SP updates the drivers causing this?
But the stranger thing is that neither Microsoft Firewall or Web Proxy services will start until I have disabled the ultrium drive.
I have to stop these services - put to manual - reboot then - manually start services after system has booted - allowing tape driver to communicate with drive first.
Previously I have re-installed an older driver and put these services to manual and all was fine - but after SP3 installation this no longer seems to be working.
Has anyone come across a similar problem and/or know where I can find the answer.
Jack
Whenever I apply an update - I have just installed SP3 -
Backup exec fails to communicate with drive. Presumably the SP updates the drivers causing this?
But the stranger thing is that neither Microsoft Firewall or Web Proxy services will start until I have disabled the ultrium drive.
I have to stop these services - put to manual - reboot then - manually start services after system has booted - allowing tape driver to communicate with drive first.
Previously I have re-installed an older driver and put these services to manual and all was fine - but after SP3 installation this no longer seems to be working.
Has anyone come across a similar problem and/or know where I can find the answer.
Jack