[b]This action will reset the current code in break mode[/b]

[regava]

I have the following problem:
1. Click on Report
2. Click on a particular report
3. click on design
4. Click on X to close the current window
5. At this point the following message is displayed:
"This action will reset the current code in break mode.
Do you want to stop the running code?
* To halt the execution of the program so the Module window can be closed, select Yes.
* To leave the code in the current state, select No.
YES NO"
If I press YES the message repeats. Every time I press YES the message repeats. If I press NO. the message is gone but I cannot do any work.
The only way to get out of ACCESS is via the Task Manager.
Any help is very much appreciated.

 

[PHV]

Seems you have still some code running in your report's class module.
go to the VBE (Alt+F11) menu Execute -> Stop

Hope This Helps, PH.
FAQ219-2884
FAQ181-2886

 

[regava]

PHV thank you for your reply. Upon further investigation I found that there was a mistake in the query that was feeding the fields to be printed in the report. All is well.