Avaya Definity Fresh Start

[printexcorporation]

Good morning

Let me start by saying this has been a year's long project of mine. I have finally found and purchased all the proper equipment with proper licenses:

Prologix G3 switch with TN2402 Processor R9.5, TN2182C Tone Clock, & TN799DP – CLAN
Avaya Intuity MAP5P – R5.1.56 SW – CLSN – 4 Port W/ (2) new backup tapes with 713 terminal rendering the 799DP useless for now

I am willing to pay a tech to walk me through this process to get everything up and running properly. I don't need anything complicated, just 5 extensions with an auto attendant and voicemail. I know this is overkill for only 5 stations, but this is what I'm looking for.

Thanks!

 

[dialtonebone]

How far in are you? Have you gotten to a terminal with a login?

 

[printexcorporation]

I'm logged in and I set my first station/extension. That's all I've done. I also don't think I have it wired up correctly from the back.

Since I'm unfamiliar with how to breakout a 25 pair using a punch block, I'm using the harmonica adapters.

 

[dialtonebone]

I'm logged in and I set my first station/extension. That's all I've done. I also don't think I have it wired up correctly from the back.

Since I'm unfamiliar with how to breakout a 25 pair using a punch block, I'm using the harmonica adapters.

And can you successfully do a save trans?

Would you mind sharing a few details?
"display sys cust"
"display alarms"
"list conf all"
and share these? Maybe hide your SID if it shows.

 

[printexcorporation]

I really appreciate you taking the time to help me out. Here's the reports you asked for, thanks!

 

[dialtonebone]

Awesome. Someone else will need to chime in on the Intuity side of this. That's something I am not as familiar with on this old of a switch. They are usually an adjunct and will be administered separate from the CM/Definity.

For the "Display alarms" -- type the command, enter submit. Then share the results.

For an auto attendant driven out of the PBX you need a TN2501 or TN750. This will let you store announcements for menus. Then, using "change vector XX" you can write a vector (call routing/decision tree/menu/auto attendant). Attach it to an extension with "add vdn XXXX".


Are you printing and scanning these? Can you access the system over IP yet? Try and get a link light on your TN799/CLAN and your data switch. After that, assign it an IP and enable it for telnet SAT. "add ip-interface" and "change ip-services", if my mind is recalling this right.

 

[printexcorporation]

Yes, I'm currently printing these and scanning them in. I will need to set up a computer in here to access via LAN