Avaya ANL16 port busy

[2gordo]

I need a fix for analog ports that in the li conf screen show "t" but can not be assigned to a station. I X-ported before I busied the analog station. Now when assigning the port to a station you get an error message, that the port has already been assigned. IDEAS?????

 

[1a22ip]

u=unassigned t=tti p=psa This means the port is open and ready for use

Hope this helps
ED

1a2 to ip I seen it all

 

[mikeydidit]

I am not sure if they ever got the problems fixed with TTI. At one time AT&T/Lucent/Avaya had some “bug” in the software that would overwrite some things on the station forms. I disabled TTI in my switch. (My thoughts being my station forms being correct meant more than TTI was useful).

But this is just my opinion.


Mike Jones
LSUHSC

 

[orypecos]

Analog boards will some times have troubles with them if the pbx looses power. Usually a busy and release of the board fixes it.

 

[2gordo]

Thank you for the responding. This is a real pain.I have tried to busy/rel the systemem tells me the port does not exist. I try to assign it to a station the system says it has already been assigned. I display port the system says the port is assigned.I have unassigned it from t to u on the board now I can't change it back. A detail I left out is, this port is located on a epn and the system is a G3rV6.

 

[1a22ip]

Is this only one port on the card? If so try to "FROG" the card. By Frog I mean swapping it with a card known to be ok. If the problem moves with the card then replace the card. If the problem stays the problem is in the switch.

Try it and see

Hope this helps
ED

1a2 to ip I seen it all