Attendant Power Port

[DRNurse]

Any ideas how this works exactly, I can't find any useful docs in NTP's.
I have PWR ports programmed on the PABX for the Attendant consoles, however how do they "link" to the consoles on the switch.
There's nothing in Attendant DB or 2250 printout, and LD 14 only let's you create/chg/mov the ports?

 

[johnpoole]

on the 25 pair amp the red/blue(pair 6) is neg (tip) and the red orange(pair 7) is positive.. all the programing does is oosmlt that port.. if you didn't program pwr it would work the same way, but making it a pwr tn removes it from the luvu table.. i don't use pwr if the console is within 100 ft of the switch.. if the lcd's are dark enough without pwr, i don't waste the tn's... i have used remote power where tn's were short... here we use two pwr tn's per console, overkill but then i didn't do the install

john poole
bellsouth business
columbia,sc

 

[DRNurse]

Thanks for that, good explanation.
If we've moved the SWB to within 100ft of the PABX, which commands do I use to out them?

 

[johnpoole]

out
pwr in ld 12

john poole
bellsouth business
columbia,sc