ASA

[btrain8]

I'm looking to find out how ASA is setup to connect. I have 2 CLAN boards with ip addresses that end in .33 and .34. my ASA properties are set to connect to ip address .32. I have to move the cables for my clan boards from 1 network switch to another. What will happen to my ASA connection when this happens if anything and how do I get around that if there's an impact as I won't be able to do anything on the switch if I lose my connection?

 

[Mitch672]

usually your ASA would be set to connect to the IP of your S-Series server, if you have an S87XX, you would use the "Active" IP (as opposed to Server A or Server B)

You can use your CLANs, if you add a "SAT" service to each CLAN, on the "change ip-services" form.

mitch


AVAYA Certified Specialist

 

[btrain8]

If I want to use dialup in case I lose the IP connectivity.. in ASA I can setup to use a modem but what happens when it dials in. Someone mentioned having to login with an adminras account first and then lauch asa..

 

[Mitch672]

yes, you need to create a login of type "remote", with a password, when you RAS in, you login with this remote login/pw, then the PPP connection assigns you an IP address, and you connect to that IP address, for CM, Web, etc.

mitch


AVAYA Certified Specialist

 

[btrain8]

all using ASA?

 

[Mitch672]

Depends on what version of CM you have, CM4 & CM5, logins are administered in the web page, CM3 or lower, yes, you ad logins in CM.

Mitch


AVAYA Certified Specialist

 

[btrain8]

When I moved my CLAN connections it was so fast that I didn't lose my ASA thankfully. However, I was messing around a bit and couldn't seem to figure out how to set ASA up via dialup. is there formal doc on this?

I can't configure ASA to be dialup via modem and enter my switch # in there and get a login prompt I can just use my ID and pword with? i'm not clear on what I'm supposed to do.

 

[phoneguy55]

Care of Mikeydidit.

http://www.tek-tips.com/faqs.cfm?fid=6415