ANI Caller ID

[a1pickle]

I recently had ISDN t-1s with ANI installed. I route the calls via VDN/vectors to hunt groups. How can I get the caller ID number to display on the 6416D+M after routing? Switch = Definity G3si v12. The name of the VDN/Vector displays now.

 

[bwilch]

You could put the ANI in teh VDN/Vector name field.

 

[SF0751]

On the trunk group form, page 2, check for "Send Connected Number". I think that this needs to be set to YES if you want the ANI of the calling party to be displayed.

Susan
"A positive attitude may not solve all your problems, but it will annoy enough people to make it worth the effort."
- Herm Albright (1876 - 1944)

 

[bettyr]

That only applies to outbound calls.

Send Calling Number:
Specifies whether the calling party’s number is sent on outgoing or tandemed ISDN calls. Valid entries are y, n, or r (restricted). If y is entered, the ISDN Numbering - Public/Unknown Format screen is accessed to construct the actual number to be sent, or the ISDN Numbering-Private screen (based on the Numbering Format field) is used. If the value is r, the calling number is sent “presentation restricted.”

 

[huffer]

Yes.... but....SF0751 did not mention the "Send Calling Number" but the "Send Connected Number" parameter:

Send Connected Number
Appears if the QSIG Value-Added field on the Trunk Group screen is n. Specifies if the connected party’s number is sent on incoming or tandemed ISDN calls. Valid entries are y, n, or r (restricted). If y is entered, the ISDN numbering - Public/Unknown Format screen is accessed to construct the actual number sent, or the ISDN Numbering - Private screen (based on the Numbering Format field) is used. If the value is r, the connected number is sent "presentation restricted." The Send Connected Number field must be set to y in order for the Calling Party Number of an incoming ISDN call to display at the transferred-to station after a QSIG transfer operation

 

[bettyr]

no luck with that either.

 

[84Mike]

Try 'change vdn xxxx'
set 'allow vdn override' to 'y'

I have a 4-digit DNIS over our T1's, and the calling number is passed all the way to the display on the phone. I, too, am routing thru VDN/vectors.

 

[huffer]

What does the display read exactly at this moment? And how do you want it to look exactly?