Analog line programming trouble

[omer99]

Hi guys I have a IPO release 9.05 and I have a weird issue when trying to modify the programming of my analog lines.I want to allow trunk to trunk transfer.I go the the first line,modify the programming and click ok.When I move to program line 2,the manager sticks on line 1.Whatever line i try the manager still sticks on line 1.Does anyone have a clue?

 

[Westi]

sounds like a Manager problem.
Have you tried a different release?

Joe W.

FHandw, ACSS (SME)


"This is the end of the world, make sure to buy your T-shirt before it is too late"
Original expression of my daughter

 

[omer99]

Yes 3 different releases on 2 computers

 

[holdmusic34]

Corrupt config.

Try deleting the lines and booting with the cards unseated. Then shutdown and whack em back in.

You likely can't change extensions either.
Restore the config from a recent back up.
Don't have one?
You will in the future after you default the config and write from scratch.

Q: why are pirates so mean?
A Because they arrrrr.

 

[intrigrant]

In Manager delete the lines first, then delete the ATM card, then reboot and reconfigure the lines.
If it is a Combo card then first delete the extension numbers, then delete the extensions, then delete the analog lines of that card, then delete the card and reboot.
After reboot renumber the extensions, reprogram the lines and remove the automatic created users.
Done.

 

[DKThomas]

I have had the same issue after downgrading from 9.1.x to anything 9.0.x. I have had to default the config after the downgrade in order to program anything with the lines. Of course, this is on initial programming, not done it yet with an installed system. We are using all 500V2 units, mostly DS cards with analog boards and 95xx phones. Very basic systems in our clinics.

 

[amriddle01]

It's the 9.1 Manager that does it, it sucks