Analog call forward to external number 1

[fonegal]

Has anyone had any sucess forwarding a asm port to an external number on a mics 6.1?

 

[BiscuitJack]

You have to turn on "Allow Redirect" per analog port and then use a butt set to access port receive dial tone and input the call forward access code then the dial access code plus external number. Then test

 

[exsmogger]

You'll also need to setup a route (001 for example) to dial out on a line or a pool (pool is preferable). Then setup a destination code (9 for example) and program the destination code to use route 001. To forward you would then go off-hook, do a hook flash, dial *4, dial 9, then dial the external number. Do a hook flash and dial #4 to cancel forwarding.

Brian Cox

http://www.jandjcommunications.com

http://groups.to/jandj/

(updated 3-13-09)

http://phonewire.blogspot.com/

(updated 3-13-09)

 

[YnotPhone]

Enhanced ATA, ATA2 Access Codes

All access codes must be preceded with a
-> Flash Hook /Flash (or Link) then:

*4 Call Forward
#4 Cancel Call Forward
*74 Call Park (No way of knowing which call park code is used)
*75 Call Pickup Group
*76 Call Pickup Directed
*801 Call Queuing (Call Waiting)
*82 Camp-on
*3 Conference
#3 Conference Splitting
*79 Exclusive Hold
2 Hold (on and off)
5 Last Number Redial
*64 Line Pool Access (plus pool code)
*60 General Page (plus page code)(plus page zone)
*61 Page Sets (plus page zone)
*62 Page External
*63 Page Sets and External (plus page zone)
*69 Priority Call
*83 Privacy Control
*71 Link CO
*78 Pause
*72 Timed Release
*68 Restriction Override (plus password)
*2 Ring Again
#2 Ring Again Cancel
*67 Save Number (save and redial)
*1 Send Message
#1 Send Message Cancel
*0 System Speed Dial (plus code)
*809 Tones On
#809 Tones Off
*70 Transfer
*800 Trunk Answer (Service Mode)
*66 Voice Call
*981 Voice Mail Access
*980 Voice Mail Leave Message
*986 Voice Mail Transfer