Alchemy S0 to GSM ISDN2 Gateway

[daffymd]

I have got an ISDN2 to GSM Gateway on trial to try with a couple of different types phone systems that we maintain so I thought I would try it on an Argent Office and POTS16 with S0 module attached.

I can get the ISDN link up between S0 and GSM Gateway but can't route calls from analogue phone via attached POTS16 out via the gateway (I tried just changing the default ?.Dial to point out on line 701).

I think that it probably won't work but wondered if any of you guys had any other ideas/suggestions.

 

[Silverblade]

It has been a long time since i've seen a argent. But isn't it possible to give the lines that are connected to the gsm gateway an another id. (Standard it's id 0) And then set your ?. dial feature to call out via the new line id.

I also have a other suggestion but this depends on your gsm gateway. Connect it on a bri port and let the gsm gateway simmulate a isdn.
This is the way i nowdays connect a gsm gateway cause in the past i had some instability problems when i connected a gsm gateway via a so port.

Goodluck Testing