Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Aironet 1310 Removing Install mode, command needed 1

Status
Not open for further replies.
tsap1

tsap1

IS-IT--Management
Joined
Jan 30, 2006
Messages
4
Location
CA
I need to know the complete command line 'commands' to turn off “Install Mode” on a Cisco Aironet 1310 radio. Please show command line detail from login to write mem and exit.

Thanks
 
Sort by date Sort by votes
AP#conf t
Enter configuration commands, one per line. End with CNTL/Z.
AP(config)#interface dot11radio0
AP(config-if)#station role ** choose your role from list **(install, non-root, root, scanner)
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

stanlyn
  • Locked
  • Question Question
HowTo Install Multiple PAP2T ATA Devices on Same Lan
Replies
3
Views
669
iggsterman
iggsterman
BleuBell
  • Locked
  • Question Question
Command Rejected : Exceeded NNI ports Allowed
Replies
0
Views
332
BleuBell
BleuBell
dogg1
  • Locked
  • Question Question
CUCM SNMP Set Command
Replies
1
Views
687
whykap
whykap
KevinHJones
  • Locked
  • Question Question
Standalone AP mode reset
Replies
1
Views
467
ADB100
ADB100
xzeneize10
  • Locked
  • Question Question
cisco Aironet 2600 and cisco 2960x
Replies
3
Views
407
Silverblade
Silverblade

Part and Inventory Search

Sponsor

Back
Top