Adding an additional static route to a VPN tunnel

[Smooth23]

HI,

I have a vpn site site 2 site setup (Madrid and London) and over the weekend i have added a second subnet to London.

Now Madrid need to see this subnet and pinging is unsuccessful. So i figure i need to add a static route in the WatchGuard x1000 box !!!

I attempted the following:

Policy manager
Network
Branch office VPN
Manual IPSec
Add

It was here i added the route but after saving the config, i was still unable to ping the new subnet from Madrid!!!

I then removed that entry then went to

Network
Routes
add 'Madrid network address' -> 'gateway on the new London subnet'

Saved config but again, i was unable to ping from new subnet in London to Madrid or from Madrid to new subnet in London!!!

Does anyone know how to get Madrid talking to new Subnet in London office.

Many thanks in advance!!!

 

[pankajchawla]

Adding a route in Network>>routes is not going to help.

You need to add a new tunel chosing the same gateway.go to
Policy manager>>Network>>Branch office VPN>>Manual IPSec

Click tunnel>>add>>chose the existing gateway used for the VPN>>give this tunnel a diffrent name and say ok

Now you come back to manual ipsec window and click add
Punch the local and new remote network with new tunnel chosen from the drop down.

Do the same on the remote and edit the "ANY" service accordingly on both sides.