Adding a superloop on the option 81c

[lozan]

I am adding another superloop to the option 81c. I am a bit confused on where the physical cables (on the backpanel) are connected. I tried following the manual but it did not really help.

 

[johnpoole]

cable goes from the controller to the rear of the ipe. where it goes on that ipe depends on the config of that loop, if it's a single loop just glance at any other ipe with a single loop config. i think it's the upper right connector, i can look when i get to work

john poole
bellsouth business
columbia,sc

 

[mluckie1]

On the back of the IPE shelf it would go on the one marked as 0. Config in ld 97, first SUPL then XPE.

 

[johnpoole]

xpe then supl sir

john poole
bellsouth business
columbia,sc

 

[mluckie1]

I always get confused with that. Usually realize when XPE0 prompt appears.

 

[lozan]

thanks!!