Add a Static Route to Cisco 2600 Router

[StockcarsRus]

I need to add a static route that says:

All "SSL" traffic originating from my PC and destined for xxx.xxx.x.x and xxx.xxx.x.x should be routed to a LAN devices LAN interface address xxx.xxx.xx.x

I don't know the syntax to do this. Any help would be appreciated.

Also, I only want this to happen if it is SSL traffic from my PC otherwise my PC should go out the firewall as normal.

 

[Caliope]

I think you may be asking the impossible.

I have not personally set up anything like this before but I do know that there is a facility on Cisco routers called Policy Based Routing. This may be your saviour.

 

[jneiberger]

Yes, you need Policy Based Routing. Look up that term on CCO and you'll find everything you need to know. PBR is quite handy when you need to make a more complex routing decision than the router would normally make.

John