Access Codes

[nVs46]

Is there a report that can be ran for access codes that have been used on the 2400IPX? I know you can program them individually in ASPA but I need to see if anyone has used a specific one and when. Thanks in advanced.....

 

[grh959]

Try command LNPD

 

[ethereal112]

will this command show when the access code was used and by what station?

 

[MercuryComm]

The only command available that I know of to get you close would be the ATRF (Assignment of Traffic) command. You can set up the command using type 6, which is Service Peg Count, set up the interval, and where to save or print the report to. I have not used this in a loooong time, but from what I remember it will only flag how many times the feature was used during the interval you programmed when you set it up. I do not recall it reporting the use of the feature at the station level. So in summery it will basically give you the number of times the service feature was set or cancelled in the whole switch during the interval.
Good Luck!!

 

[ethereal112]

So you will need to turn it on for traffic that will be present to future? and will not give me a past history on the report because it wasn't initiated?

 

[MercuryComm]

That is correct. It will not collect data until you program the switch to do so.