Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

a stupid question?

Status
Not open for further replies.

NettableWalker

IS-IT--Management
Joined
Jun 18, 2005
Messages
215
Location
GB
Hi everyone.

This is probably stupid question but i can't think how to do it:

I've got a Cisco 837 and a /29 netblock.

I've set the ip address on the dialer1 interface to xx.xx.xx.129 255.255.255.248, how do i also get it to accept connections on xx.xx.xx.130, .131, etc?

 
Do you mean assign NAT (Address Translation) for those other publics to an internal server?
 
I think I did this before, you add secondary ip's to the same interface, just add sec at the end i.e

ip address xx.xx.xx.130 255.255.255.248 sec

Then I used nat translations to forward to services inside the network
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top