6509 IOS SLB

[phred4u]

Good day all.

I seem to have an issue and was wondering if anyone could help.

I have two 6509's with the 720SUP modules and MSFC3's in each and cannot seem to get the IOS SLB commands on the MSFCs. They are just not there. The only "ip slb" command available is the "mode".

I have checked Cisco's website and the code I'm running does support the IOS SLB functionality (I'm running IOS (tm) MSFC3 Software (C6MSFC3-PK9SV-M), Version 12.2(17d)SXB1, just for record)

Is it an issue with the MSFC3 cards ?
Is a code revsion change needed ?

I am a bit at a loss, so any help would be greatly appreciated.

Thanks in advance !