Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

5402 Ringer Off

Status
Not open for further replies.

IPcruiser

Technical User
May 14, 2004
16
GB
Is it possible to turn off the ringer on a 5402?
 
Why would you want to do this? It's a phone, it's designed to ring when someone calls it! I assume you have turned the ringer right down!

ACS - IP Office Implement
 
Its in a recording studio and they need to be able to disable the ringer, flashing light ring would be nice but i dont think you can do that either on a 5402
 
You could try to use Ring delay on the user under the tlephony tab.

Ring Delay: Default = Blank (Use system setting), Range = 0 (use system setting) to 98 seconds, Software level = 3.2+.
This setting is used when any of the user's programmed appearance buttons is set to Delayed ringing. Calls received on that button will initially only alert visually. Audible alerting will only occur after the ring delay has expired.

y1pzZTEUdok1vrI5cLb3FdPX4PgTPlSONkb5WPjz0x50etSujaMSmhdRCbOx9vASnrRNzzXv0IxNQA

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________
 
5602 IP phones will allow you to turn the ringer off but not 5402's.

Or they will on 4.2 anyway.

Jamie Green

ACA:Implement - IP Office
ACS:Implement - IP Office


Football is not a matter of life and death-It is far more important!!!!
 
I noticed that too

The 1600 do silence and i thought the 54xx and not the 56xx to be honest

But i am not sure (can't test now)

Must be 4.2

ACA - Implement IP Office
ACS - Implement IP Office
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!
 
I noticed it on a 4.2 install (ip firmware 2.8.something!!). press the Vol Down and eventually the ringer goes off. not sure about 5610's. Going there today so might give it a go on them.

I like the fact that the date and time is displayed all the time on 4.2 5410's. Shame they didn't do it on 56xx's!!!

Jamie Green

ACA:Implement - IP Office
ACS:Implement - IP Office


Football is not a matter of life and death-It is far more important!!!!
 
i know.

saves a button.

@IPCruiser, sell them a 5410, only about £50 more
 
You could make a virtual number, programm a bridged appereance button on the 5402 put it on No Ring and route the ICR to the virtual number.

y1pzZTEUdok1vrI5cLb3FdPX4PgTPlSONkb5WPjz0x50etSujaMSmhdRCbOx9vASnrRNzzXv0IxNQA

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________
 
For internal, programm a short code with the extension number dail to the virtual number.

y1pzZTEUdok1vrI5cLb3FdPX4PgTPlSONkb5WPjz0x50etSujaMSmhdRCbOx9vASnrRNzzXv0IxNQA

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top